Flex-Tec is leaving lines and streaks on my piece...

Flex-Tec is a thinner coating material than Glaze-Tech and will leave a streaked surface on your pieces as it flows across them. On flat pieces it is easier to level your surface, create a dam around the piece (masking tape works well) and allow the Flex-Tec to self-level.

When applied to curved surfaces, the Flex-Tec will run and create a more streaked appearance.

Just be aware that from far away and if coated on the interior of colored pieces, this effect will never be seen.

Have more questions? Submit a request


Article is closed for comments.
Powered by Zendesk